Oce ColorWave 650, User Manual

Page: 277 / 336

Set the 'Print while RIP' setting
Introduction
This setting is a performance optimization setting. When “Print while RIP” is enabled,
for 'Express' and 'Express Plus' prints, the printer starts to print an image during rasteri-
zation of the image. Occasionally the rasterization of the image cannot keep up with the
print speed. In such cases, the print process will be aborted (error code 22801) and the
print will be recovered afterwards. To prevent this you can disable this setting. Even when
disabled, the printer still starts to print rasterized pages before all pages of a job are raster-
ized.
You can choose one of following values.
• 'Enabled'
This is the default setting.
• 'Disabled'
Select this value if you often encounter error code 22801.
Before you begin
This setting is editable for the Key operator or Power user.
How to set the 'Print while RIP' setting
1.
Click 'Preferences' - 'System properties'.
2.
Click 'Edit' in the 'Printer properties' bar or click the value of the 'Print while RIP' setting.
3.
Select the correct value.
Select 'Enabled' if print productivity is an important factor.
4.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
Chapter 8 - Print quality and Print productivity 277
Set the 'Print while RIP' setting