Oce ColorWave 650, User Manual

Page: 249 / 336

Configure the media sizes
Introduction
You must indicate in the Océ Express WebTools the following settings.
• The core size of the media rolls
• The media sizes
Note:
The media sizes and core sizes can only be edited by the Key Operator or Power User.
How to define the core size of the media
1.
Navigate to 'Configuration' - 'Printer setup' in the Océ Express WebTools.
2.
Click 'Edit' in the 'Media' bar or click the value of the 'Two-inch core used' setting if
you also use 2 inch cores.
The standard roll core size for the Océ ColorWave 650 Poster Printer is 3 inch. If 'Two-
inch core used' is enabled, the printer will ask the used core size when loading a media
roll.
3.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
How to define the media sizes
1.
Navigate to the 'Support' - 'Media' tab in the Océ Express WebTools.
2.
Click on the value of the 'Supported media sizes' setting. A new window opens.
3.
Select a media series from the drop-down list. For each of the standard media series
('ANSI small', 'DIN', 'ANSI mixed' or 'DIN Carto') a set of media sizes is enabled.
4.
You can enable or disable media sizes to fine-tune the system to your environment. The
media series will then automatically change into a 'Custom' media series.
5.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
Note:
You cannot disable media sizes that are currently loaded on the printer.
Note:
When you load a media roll the printer automatically detects the roll width. If the detected
roll width is not a standard width, the printer selects the next smaller roll width that is
supported by the printer.
Chapter 7 - Manage media on the Océ ColorWave 650 Poster Printer printing system 249
Configure the media sizes