Oce ColorWave 650, User Manual

Page: 124 / 336

Access control and IPsec settings
Introduction
When 'Access control' is enabled, you can edit the 'Access control' settings.
Caution:
To prevent unauthorized access to these settings via the printer operator panel, please
ensure that the 'Password to change network settings' is set.
'Access control' and 'IPsec' settings
The following settings for 'Access control' are available for each of the 5 stations:
#
Description Setting
'Enable or disable communication of this host with the printer.' "Access control
station X : En-
able"
'The IPv4 address of this host is allowed to connect to the printer.' "Access control
station X: IP ad-
dress"
Enable or disable 'IPsec'. 'IPsec' is a security protocol that encrypts
the communication between the host and the printer. "IPsec station X"
'The key for encryption of this host connected via IPsec. If empty,
the default preshared key is used.' "Access control
Preshared key"
Note:
'Enable or disable IPsec. IPsec restricts access to the printer over IPv4. It also encrypts
the communication between the hosts and the printer. Note that when IPv6 is enabled
also, traffic over IPv6 is not restricted, nor encrypted.'
Additionally the following 'IPsec' settings are available. (For details on these settings,
please consult the Security manual)
#
Description Setting
This is the default key for encryption of hosts connected via
'IPsec'. This key holds for all stations whose preshared key is un-
specified. 'Default pre-
shared key'
Chapter 4 - Configure the printing system 124
Access control and IPsec settings