Oce ColorWave 650, User Manual

Page: 122 / 336

Enable Access control
Introduction
With 'Access control' disabled, any host within your network has direct access to the Océ
ColorWave 650 Poster Printer. With 'Access control' enabled, you are able to choose up
to 5 hosts that are allowed to communicate with the Océ ColorWave 650 Poster Printer
through your network. This amount of hosts allows for flexible configuration:
• 2 mandatory hosts: the Print server and the Scan server
• 1 host that is used by the 'System administrator' to configure the Océ ColorWave 650
Poster Printer
• 2 mandatory hosts:
For each of the hosts, you can decide whether the communication from this host to the
system needs to be encrypted by IPsec.
You can enable 'Access control' in the Océ Express WebTools.
Note:
The option to enable 'Access control' as well as the 'Access control' settings are only
visible and configurable if the 'Configuration' – 'Connectivity' – 'Network adapter' -
'Enable DHCP' setting is disabled.
Note:
'Access control' is not compatible with 'IPv6'. To change the IP type, please see: ‘Define
the IP type’ on page 121
Note:
'Configuration' of the 'Access control' settings is only available to the 'System adminis-
trator'.
Caution:
To prevent unauthorized access to these settings via the printer operator panel, please
ensure that the 'Password to change network settings' is set.
Enable 'Access control'
1.
Open Océ Express WebTools and log in as 'System administrator'or as 'Power user'.
2. Open the 'Configuration' - 'Connectivity' tab.
Chapter 4 - Configure the printing system 122
Enable Access control