Oce Colorado 1640, Operation Manual

Page: 77 / 194

Cut and unload media
Cut the media
Introduction
When you cut media, the printer uses the embedded knife.
You can also cut the media manually with your own knife. How the media is cut depends on the
media type configuration in the RIP. For more information, see
Change the media settings on
page 44 .
Procedure
1. On the operator panel tap on the [Cut] icon on the top right.
2. Move the media guides to the sides.
3. When a tension bar is present, a window telling you to remove the tension bar opens. Remove
the tension bar from the media path and tap on [Completed].
The embedded knife cuts the media.
4. Tape the trailing edge to the take-up media roll in case of winding.
Cut and unload media
Chapter 3 - Handle the media 77