Oce Arizona 400 Series GT, User Manual

Page: 81 / 270

How to Manage Print Jobs
Daily Start-up and Shut-down
Introduction
Keep your printer clean and perform all recommended scheduled maintenance to ensure
that the printer is ready to produce optimal quality images.
When to do
The start-up procedure must be performed every morning or after a period of time when
the printer has not been used. The shut-down procedure indicated here is for the end of
a regular workday. If the printer is shut down for longer periods of time than a few days,
then there are more considerations, as documented in the previous section on How to
Switch the Printer Off (see the note on Extended Power Off).
Start-up Procedure
1.
Turn on the ink heater (click on the Ink Temperature Control icon located on the
Command Toolbar of the Job Control screen).
2.
Clean the carriage underside.
3. Perform Printhead Maintenance after the ink temperature has reached at least 40° C
(104° F).
Note:
Refer to the Maintenance chapter for details on how to perform these procedures.
Shut-down Procedure
1.
Turn off the UV lamps (click on the lamp icon located on the Command Toolbar of the
Job Control screen).
2.
Turn off the table vacuum.
3.
If it is the end of the work week, swab the printheads.
4. Turn off the ink heater (click on the Ink Temperature Control icon located on the
Command Toolbar of the Job Control screen).
5.
Do not power off the printer (unless the printer will not used for more than 14 days - in
that case call your service representative).
Chapter 5 - How to Operate Your Océ Arizona Printer 81
Daily Start-up and Shut-down