Oce 1000C, Job Management Manual

Page: 63 / 206

3
3-5 Starting up and logging in
Access levels
The three possible levels of access to Command WorkStation or Command
WorkStation LE are Administrator, Operator, or Guest. To enable maximum password
protection, Administrator and Operator passwords must be specified in Setup (see the
Configuration Guide ).
Once the Administrator and Operator passwords have been specified, the access levels
are as follows:
N
OTE
:
In Command WorkStation, a user can be logged in as Administrator on one
Océ 1000C, as Operator on a second Océ 1000C, and as Guest on a third
Océ 1000C. In these instances, the levels of access are dependent either on the
Océ 1000C currently selected in the Active Jobs window or on the Océ 1000C that
holds the currently selected job.
By default, no passwords are set on the Océ 1000C—in this default state, anyone can
perform Setup and use all Command WorkStation and Command WorkStation LE
functions. Until an Administrator password is defined in Océ 1000C Setup, you can
log in to the Océ 1000C as Administrator without entering a password and are given
full privileges.
After the administrator has performed Setup and specified passwords, Command
WorkStation and Command WorkStation LE user options depend on your login level.
This manual assumes that you are logged in to the Océ 1000C as Operator.
Access level Privileges and password requirements
Administrator Has full access to all Command WorkStation and Command
WorkStation LE functions. Administrator password required. For a
description of the full range of tasks an administrator can implement,
see the
Configuration Guide
.
Operator Has access to all Command WorkStation functions, except Setup, font
management, reordering job priority, restarting the Océ 1000C,
clearing the Océ 1000C hard disk drive, and clearing the Job Log.
Operator password required.
Guest Can view job status, but cannot make changes to jobs or Setup, and
cannot access the Job Log. No password required.