Oase FiltoSmart 60, Operating Instructions Manual

Page: 16 / 20

- EN -
16 FiltoSmart 60
Establishing the connections
Assembling the suction unit
How to proceed:

H
• Assemble the suction unit.
Assembling the flow-out unit
How to proceed:

I
• Assemble the flow-out unit.
– The water distributor can be used instead of the
flow-out pipe.
Connecting the hose
The procedure is identical for the inlet (IN) and outlet
(OUT).
How to proceed:

J
1. Shorten the hose to the required length.
– Chose the length so that the hose cannot kink in
the intended installation position.
2. Screw the union nut onto the hose connector of
the connection unit.
3. Push the hose onto the hose connector and turn
the union nut counter-clockwise to fix the hose in
place.
4. Push the other end of the hose onto the hose
connector at the suction unit/flow-out unit and
turn the union nut counter-clockwise to fix the
hose in place.

C
• Fasten the suction unit and flow-out unit in the
aquarium using suction cups.
COMMISSIONING/START-UP
N O T E
Thoroughly rinse out all filter material with warm tap
water before using for the first time in order to
remove any soiling. (→ Cleaning/replacing the filter
media)
N O T E
Ensure that the pump never runs dry!
The pump will be destroyed.
• Regularly check the water level and circulation in
the filter and in the aquarium.
How to proceed:

N
• Completely fill the container with water and place
it next to the aquarium.
• Route the power connection cable such that it
forms a drip loop!
Switching on: Connect the unit to the mains. The unit
switches on immediately. When the unit is switched
on, it takes several minutes f or the air to escape from
the unit (this makes a noise).
Switching off: Disconnect the unit from the mains.