![background image](http://html2.mh-extra.com/html/oakley/5u/5u_builders-manual_3108376017.webp)
ASV Socket Board issue 1 & 1.1 Parts List
Miscellaneous
2 x 8 way 0.1” boxed header *
HDR1, HDR2, HDR3
Switchcraft 112APCX 1/4” socket **
SK1 – SK20.
* HDR1, HDR2 and HDR3 are mounted on the underside of the board. They should be fitted first.
Pin 1 lines up with the square pad on the PCB. Pin 1 is normally depicted by a small triangle on the
body of the header.
** Do read the section on building socket boards in the Oakley Construction Guide.
Interconnects
2 x 8 way 0.1” IDC socket
6 off
16 way 0.05” IDC ribbon cable
0.3 metres
Additional Hardware
For securing the main board to the pot/switch board, and the main board to the VCO board, you can
use male-female spacers. See assembly section later for more details.
Four off 11mm M3 Male-Female hex spacers.
Eight off M3 toothed washers
Four off M3 6mm screws
Twelve off M3 flat washers
Four M3 nuts
On the VCO board the two large temp co resistors straddle the THAT300 NPN array so that all three devices are
physically touching each other. A non conductive thermal paste or epoxy can be used to bond them together but I
find this is not normally necessary.
17