O-Two e600, User Manual, Page: 20 / 56

16
e600 User Manual
(15PL1010 - Rev.7 28_8_2017) English version
4.1.4 Connecting Patient Circuit
1. Attach the O-Two patient circuit (Figure 3) to 22mm gas output
connector (S) in Figure 2.
2. Connect the 2 sensor hoses (V) in Figure 3 of the patient circuit to their
corresponding connectors (Q) & (R) in Figure 2.
3. DO NOT connect the patient circuit to a patient until the ventilator is
turned on (Step 4.1.5) and three Solid Silhouettes start-up figures
(Shown in Figure 6) are displayed.
4.1.5 Turning Ventilator ON
To turn on the ventilator, Press the ON/OFF button (N) in Figure 1 for one
second. During that second the associated green LED will start blinking at a
high frequency. After 1 second the ventilator will turn on but with no
ventilation at this point.
If the button is pressed and released for less than a second, the ventilator will
remain OFF.
Note

Do not connect the patient circuit to a patient or the test lung before
turning on the ventilator.

A/C V with volume control (VCV) is the default start-up ventilation
mode for e600.
4.2 Pre-use Check
The following check must be performed and confirmed by the Health care provider
in the following cases:

Prior to use

After replacing hoses, patient circuits or batteries.

At least every 6 months.
1 Visually inspect the ventilator for mechanical damage
2 Ensure that battery is fully charged.
3
Ensure the e600 is connected to a gas supply (Cylinder or piping system)
that delivers a minimum of 45 PSI (3 Bar) and a maximum 87 PSI (6 Bar)
output pressure and a minimum 120 L/min flow
4 Ensure that the patient circuit and monitoring hoses have been properly
connected.