O-Two e600, User Manual, Page: 10 / 56

6
e600 User Manual
(15PL1010 - Rev.7 28_8_2017) English version
3.2 Function Keys
While all ventilation parameter settings are controlled by the Control Selection
Knob (M) in Figure 1, there are a number of key membrane buttons which
control additional ventilator functions:
3.2.1 ON/OFF
To turn on the ventilator, Press the ON/OFF button (N) in Figure 1 for one
second, during that second the associated green LED will start flashing at a
high frequency. After 1 second the ventilator will turn on but without
ventilation until the appropriate patient size symbol is selected. If the button is
pressed and released for less than a second, the ventilator will remain OFF.
To turn off the ventilator, Press and hold the ON/OFF button for 4 seconds,
the green power LED will start flashing at a high frequency. After 4 seconds
the ventilator will turn off and all ventilation will stop. If the button is pressed
and held for less than 4 seconds, the ventilator will stay ON.
Warning
At approximately 2% of full battery capacity, the ventilator will not start
when in the off position or will shut down when operating.
3.2.2 Control Selection Knob
The Control Selection Knob (M) in Figure 1 is used to navigate between
parameters, change modes, select primary function change when rotated,
and to confirm function changes when pressed. Diagram below illustrates
path of cursor when Control Selection Knob is rotated clockwise.
Key Membrane Controls
3.2.3 Lock
Lock function will disable all buttons and the Control Selection Knob except
for the ON/OFF, Alarm Silence and Day/Night buttons, which are enabled at
all times.
To lock the key membrane or cancel the lock function:
1- Press Lock button (I) in Figure 1. The Lock symbol will be displayed on
the screen.
2- To cancel the Lock function, press the Lock button (I) again.