Installation Guide for
NyxLite Gateway [NGWY1010]
Thank you for choosing NyxLite Gateway.
This product acts as a home controller for Nyx
Home Automation System.
The Box Contains- Gateway
Ethernet Cable
Installation Guide
Screws: 2 Nos.
Pin - To set DIP Switches
Technical Specifications
Operating voltage 230VAC, 50Hz
Active Current
Radio frequency
866Mhz
Radio operating
distance
50m line of sight
Operating
temperature
Dimension
Communication
ports
1 Ethernet port 10/100 Mbps
0 - 50°C
300 mA
100mm (H) x 70mm (D) x 52mm (W)
2. Connect 230V power to the gateway device.
3. Insert one end of Ethernet cable to the gateway
device and other end into one of the ethernet
port of router.
Product setup
Product setup
1. Ensure the DIP switches are set as per DIP
switch label.
A] Configuration with Wi-Fi router:
A] Configuration with Wi-Fi router:
DIP Switch
DIP
Switch
Label
4. Turn on NyxLite gateway, then PWR LED will
glow and “RUN” LED will start blinking. This
indicates that the device is working.
On-off
switch
B] Configuration using Jio Access Point:
1. To connect NyxLite gateway with Jio Access
point, you need additional Wi-Fi extender.
2. Turn on the Jio Access point and Wi-Fi
extender. (tested module viz.: MI3C).
3. Use mobile phone or computer to log-in to
the Wi-Fi extender by using its IP and
password (Generally printed on back side of
router).
B] Configuration using Jio Access Point:
Web: www.nyxhomeautomation.com
email: [email protected]
Revision04; June 2019
Configuration of Nyx devices to gateway:
1. Internet connection to the gateway is
recommended.
2. Download Nyx App on your mobile.
3. RUN the Nyx App and add the NyxLite
Gateway
Configuration of Nyx devices to gateway:
4. Give all the credentials and set-up a system.
5. Once gateway is set up, add the available
devices
Setting up additional hooter:
Setting up additional hooter:
4. Set the Wi-Fi extender to the amplifier mode
[Extend existing Wi-Fi].
5. Select existing Wi-Fi network to repeat and
enter its password. Here, existing wireless
network is Jio Access Point.
6. Now, connect Ethernet cable from NyxLite
gateway to the Wi-Fi extender.
EXT
HOOTER
Connector
Connection diagram with external hooter:
Connection diagram with external hooter:
User can connect external hooter for larger
sound. Hooter can be connected to Gateway
is as shown below.
NyxLite Gateway
Input Power
Hooter
Recommended Specifications of Hooter:
Max Operating voltage: 230VAC
Max Operating current: 1Amp
Recommended Specifications of Hooter:
7.
.
8. LED indication status on Ethernet connector
of NyxLite Gateway:
GREEN:
Continuous ON
Orange:
Blink during router communication
Turn on NyxLite gateway. Then the “PWR”
LED will glow and “RUN” LED will start
blinking. This indicates that the device is
working
Pre-installation check list
:
1. Install gateway at center location of home.