9
Connect LED Power Cable
You need to connect the LED power cable so that the RGB LED lights on each speaker can be powered.
• Firmly insert the power plug of a speaker to a 3.5mm jack marked
LED POWER
on the back of the main unit.
Repeat the step above to connect other four speakers’ LED cables to the
LED POWER
jacks each.
Connect the plugs of the LED power cables to
LED POWER
jacks only. Never connect these plugs to any
other sockets on the back of the main unit.
Connect AC Power
Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the
exterior of the product.
Before you connect the AC power plug to the power socket, ensure you have completed all the other con-
nections
1.
Connect the power cable of the main unit to the power socket.
2.
Adjust the
POWER
switch on the back of the main unit to the
ON
position.
Prepare the Remote Control
Remove the batteries from the remote control if it is not used for a long time to avoid battery leakage.
Do not mix new and old or different types of batteries in combination.
To insert the batteries in the remote control:
1.
Open the battery compartment on the back of the remote control.
2.
Insert two supplied AAA batteries with correct polarity as shown inside the battery compartment.
3.
Close the battery compartment.
Keep the remote control and the main unit within 16 feet for effective operation range.
When using the remote control, aim it towards the main unit with 30˚ angle range for effectiveness.
16
ft.
30°
30°
-
+
-
+
