NXP Semiconductors K32 L2A Series, Reference Manual, Page: 219 / 1379

Note
Hexadecimal values are designated by a preceding 0x, binary
values designated by a preceding %, and decimal values have
no preceding character.
11.5.1 ADC module initialization example
11.5.1.1 Initialization sequence
Before the ADC module can be used to complete conversions, an initialization procedure
must be performed. A typical sequence is:
1. Calibrate the ADC by following the calibration instructions in Calibration function .
2. Update CFG to select the input clock source and the divide ratio used to generate
ADCK. This register is also used for selecting sample time and low-power
configuration.
3. Update SC2 to select the conversion trigger, hardware or software, and compare
function options, if enabled.
4. Update SC3 to select whether conversions will be continuous or completed only once
(ADCO) and whether to perform hardware averaging.
5. Update SC1:SC1n registers to select whether conversions will be single-ended or
differential and to enable or disable conversion complete interrupts. Also, select the
input channel which can be used to perform conversions.
11.5.1.2 Pseudo-code example
In this example, the ADC module is set up with interrupts enabled to perform a single 10-
bit conversion at low-power with a long sample time on input channel 1, where ADCK is
derived from the bus clock divided by 1.
CFG1 = 0x98 (%10011000)
Bit 7 ADLPC 1 Configures for low power, lowers maximum clock speed.
Bit 6:5 ADIV 00 Sets the ADCK to the input clock ÷ 1.
Bit 4 ADLSMP 1 Configures for long sample time.
Bit 3:2 MODE 10 Selects the single-ended 10-bit conversion, differential 11-
bit conversion.
Bit 1:0 ADICLK 00 Selects the bus clock.
Chapter 11 Analog-to-Digital Converter (ADC)
K32 L2A Reference Manual, Rev. 2, 01/2020
NXP Semiconductors 219