
JN516x-EK001
Evaluation
Kit
User Guide
JN-UG-3093 v1.5
© NXP Laboratories UK 2015
71
5.
Once programming has completed, remove the Programming Dongle and
replace the battery compartment cover.
B.2 Re-programming JN5168 Modules
In order to re-program the Flash memory of the supplied JN5168 modules, you must
connect the Carrier Board (on which the module is located) to your PC (see below).
To perform the re-programming from your PC, you must use a JN51xx Flash
Programmer utility (see
“Flash Programmers” on page 69
).
When re-programming the JN516x modules on the Carrier Boards in this kit, you must
use one of the supplied ‘USB A to Mini B’ cables to connect a USB port of your PC to
the USB Mini B port of the Carrier Board. When you make this connection for the first
time, you may be prompted to install the device driver for the FTDI chip which is
located on the Carrier Board - if this is the case, refer to
B.3 Re-programming JN5168 USB Dongles
In order to re-program the Flash memory of the supplied JN5168 USB Dongles, you
must plug the dongle into a USB port of PC (see below). To perform the re-
programming from your PC, you must use a JN51xx Flash Programmer utility (see
“Flash Programmers” on page 69
).
When you make the USB connection for the first time, you may be prompted to install
the device driver for the FTDI chip which is located on the dongle - if this is the case,
refer to
.
Note:
The Programming Dongle can also be used as a
UART port on the Remote Control Unit for debug
purposes.
Summary of Contents for JN516x-EK001
