MCF51CN128 Reference Manual, Rev. 6
Freescale Semiconductor
18-1
Chapter 18
Modulo Timer (MTIM)
18.1
Introduction
The MTIM is a simple 8-bit timer with several software selectable clock sources and a programmable
interrupt.
NOTE
•
For MCUs that have more than one MTIM, the MTIMs are collectively
called MTIMx. For example, MTIMx for an MCU with two MTIMs
refers to MTIM1 and MTIM2.
For MCUs that have exactly one MTIM,
it is always referred to as MTIM1.
•
Use pin mux control registers from
Section 2.3, “Pin Mux Controls
” to
assign MTIM signals to the MCF51CN128 package pins.
•
Most pin functions default to GPIO and must be software configured
before using MTIM.
•
The MCF51CN128 series MCUs do not include stop1 mode. Ignore all
reference to stop1.
