NXP Semiconductors freescale KV4 Series, Reference Manual

Page: 253 / 1359

Table 14-33. Peripheral bits:
Bit [31:7] [6] [5] [4] [3] [2] [1] [0]
Peripheral Reserved Reserved Reserved Reserved CAN Slave SPI Slave I2C Slave UART
If the peripheral is available, then the corresponding bit will be set in the property value.
All reserved bits must be set to 0.
14.4.1.3 AvailableCommands Property
This property value is a bitfield with set bits indicating the commands enabled in the
flashloader. Only commands that can be sent from the host to the target are listed in the
bitfield. Response commands such as GenericResponse are excluded.
The bit number that identifies whether a command is present is the command's tag value
minus 1. 1 is subtracted from the command tag because the lowest command tag value is
0x01. To get the bit mask for a given command, use this expression:
mask = 1 << (tag - 1)
Table 14-34. Command bits:
Bit [31:
17]
[16] [15] [14] [13] [12] [11] [10] [9] [8] [7] [6] [5] [4] [3] [2] [1] [0]
Command
Reserved Reserved Reserved Reserved Reserved Reserved
SetProperty
Reset
Reserved
Execute
Reserved
GetProperty
FlashSecurityDisable
FillMemory
WriteMemory
ReadMemory
FlashEraseRegion
FlashEraseAll
14.5 Kinetis Flashloader Status Error Codes
This section describes the status error codes that the Kinetis Flashloader returns to the
host.
Table 14-35. Kinetis Flashloader Status Error Codes, sorted by Value
Error Code Value Description
kStatus_Success 0 Operation succeeded without error.
kStatus_Fail 1 Operation failed with a generic error.
Table continues on the next page...
Chapter 14 Kinetis Flashloader
KV4x Reference Manual, Rev. 2, 02/2015
Freescale Semiconductor, Inc.
Preliminary
253