NXP Semiconductors freescale KV4 Series, Reference Manual

Page: 1032 / 1359

PIT_CVALn field descriptions (continued)
Field Description
Represents the current timer value, if the timer is enabled.
NOTE: • If the timer is disabled, do not use this field as its value is unreliable.
• The timer uses a downcounter. The timer values are frozen in Debug mode if MCR[FRZ] is
set.
40.4.4 Timer Control Register (PIT_TCTRLn)
These registers contain the control bits for each timer.
Access: User read/write
Address: 4003_7000h base + 108h (16d × i), where i=0d to 3d
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
0
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0
CHN TIE TEN
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
PIT_TCTRLn field descriptions
Field Description
31–3
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
2
CHN
Chain Mode
When activated, Timer n-1 needs to expire before timer n can decrement by 1.
Timer 0 cannot be chained.
0 Timer is not chained.
1 Timer is chained to previous timer. For example, for Channel 2, if this field is set, Timer 2 is chained to
Timer 1.
1
TIE
Timer Interrupt Enable
When an interrupt is pending, or, TFLGn[TIF] is set, enabling the interrupt will immediately cause an
interrupt event. To avoid this, the associated TFLGn[TIF] must be cleared first.
0 Interrupt requests from Timer n are disabled.
1 Interrupt will be requested whenever TIF is set.
0
TEN
Timer Enable
Enables or disables the timer.
0 Timer n is disabled.
1 Timer n is enabled.
Memory map/register description
KV4x Reference Manual, Rev. 2, 02/2015
1032
Preliminary
Freescale Semiconductor, Inc.