Nvidia SN2010, Hardware User Manual

Page: 85 / 93

85
a.
b.
c.
d.
Pin Symbol Name Description Note
10 VeeR Receiver Ground (Common with Transmitter Ground) a
11 VeeR Receiver Ground (Common with Transmitter Ground) a
12 RD- Receiver Inverted DATA out. AC Coupled --
13 RD+ Receiver Non-inverted DATA out. AC Coupled --
14 VeeR Receiver Ground (Common with Transmitter Ground) a
15 VccR Receiver Power Supply --
16 VccT Transmitter Power Supply --
17 VeeT Transmitter Ground (Common with Receiver Ground) a
18 TD+ Transmitter Non-Inverted DATA in. AC Coupled --
19 TD- Transmitter Inverted DATA in. AC Coupled --
20 VeeT Transmitter Ground (Common with Receiver Ground) a
Notes:
TFAULT is an open collector/drain output, which should be pulled up with a 4.7k-10k
Ohms resistor on the host board if intended for use. Pull up voltage should be between
2.0V to Vcc + 0.3V. A high output indicates a transmitter fault caused by either the TX
bias current or the TX output power exceeding the preset alarm thresholds. A low
output indicates normal operation. In the low state, the output is pulled to <0.8V.
Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V
Should be pulled up with 4.7kΩ-10kΩ on host board to a voltage between 2.0V and
3.6V. MOD_ABS pulls line low to indicate module is plugged in.
LOS is open collector output. Should be pulled up with 4.7kΩ-10kΩ on host board to a
voltage between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates
loss of signal.
RJ-45 CONSOLE and I²C Interface
Signal Pin# Color
Not connected 1 G/W
I²C_SCL 2 G
TXD 3 O/W
Not connected 4 Bl
RJ-45 Console and I²C interfaces are integrated in the same connector. Due to that,
connecting any cable other than the Mellanox supplied console cable may cause an
I²C hang.
Using uncertified cables may damage the I²C interface. Refer to the Replacement Parts
Ordering Numbers appendix for harness details.
