45
N V I D I A C o r p o r a t i o n
C h a p t e r 5
U s i n g n V i e w M u l t i - D i s p l a y M o d e s : D u a l v i e w v s . S p a n / C l o n e
Figure 5.11
Windows 2000 Display Settings: Dualview Mode (Display 2 attached)
Enabling nView Dualview Mode After Initial Session:
Windows 2000
Switching back and forth from Dualview to Span/Clones mode under Windows
2000 is much faster
after
the initial Dualview enable session.On subsequent
Dualview enabling sessions, you can use fewer steps, as follows:
1
Follow the basic steps in
“Enabling nView Dualview Mode for the First
Time: Windows 2000” on page 40
through step 9.
2
After your computer restarts, Dualview enabling is complete. You will not
see any further Dualview messages and do not need to follow the remaining
steps.
Activating nView Dualview Mode: Windows XP
When you start Windows XP in multi-display configuration, Windows starts in
“Dualview” mode. You may only need to do an “attach” procedure to enable the
secondary display device. Follow these steps:
1
Make sure you have an NVIDIA GPU-based multi-display graphics card
installed in your computer.
nViewGuide_.book Page 45 Monday, August 11, 2003 4:03 PM