Invu by Nuvo™
User Manual
The INVU™ App
NV-UMLS-0012
39
Session Preparation Guidelines
The session preparation guidelines screens provide instructions on how to prepare and wear
your
INVU Sensor Band™
and are described in detail in section 6.5.1.
After following the preparation guidelines and applying the
INVU Sensor Band™, press “
WI-
FI ENABLED
” on the last session preparation guidelines screen. The “all set” screen is shown
and pressing “
START TRAINING SESSION”
will start the training session process.
Figure 6-13. Last preparation instruction and all set
During the training session, we check the signal of your band continuously. If we detect a
weak signal, we will guide you through improving it. Training ends after a good band signal
has been detected for a few minutes.
Note:
No clinical monitoring of you or your baby is done during training.
Note:
For a successful training session, please try to minimize your movements during the
process.
Note:
The blue light on the band Controller blinks until the training session ends or until a
weak signal or errors are detected. This indicates that the process is working properly, and
that data is transferring via the Bluetooth connection to your smartphone.
Tips for a successful monitoring session!
✓
Scrub your abdominal skin with soap and water before applying the band.
✓
Make sure you are connected to a Wi-Fi network.
✓
Start the training session at a comfortable relaxed position: sitting, reclining or laying
on your back.
✓
Minimize your movements as much as possible during the training session.
✓
Pay attention to INVU app sounds and notifications during the training session.