22
Network Camera User Manual
2. Click “Enable” and set the alarm holding time.
3. Set alarm trigger options. Trigger Email and FTP. The setup steps are the same as motion
detection. Please refer to
chapter for details.
4.3.3
Alarm Server
Go to Alarm
Alarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the
camera will transfer the alarm event to the alarm server. If an alarm server is not needed, there
is no need to configure this section.
4.4
Event Configuration
For more accuracy, here are some recommendations for installation.
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of
detection.
Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass,
lake surfaces and so on).
Avoid places that are narrow or have too much shadowing.
Avoid scenario where the object’s color is similar to the background color.
At any time of day or night, please make sure the image of the camera is clear and with
adequate and even light, avoiding overexposure or too much darkness on both sides.
4.4.1
Exception
This function can detect changes in the surveillance environment affected by the external