Package
Overview
Installation
1
2
3
4
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the
nearest service center. Never attempt to disassemble the
camera yourself.
(We shall not be responsible for any problems
caused by unauthorized
repair or maintenance.)
■
Do not allow water or liquid intrusion into the camera.
■
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is
mounted on wall or ceiling, the device shall be firmly
fixed.
■
Do not use camera beyond specified voltage range.
■
Do not drop the camera or subject it to physical shock.
■
The product must be grounded to reduce the risk of electric shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
■
Avoid pointing the camera towards the sun or other light sources.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be
-22˚F~140˚F), dusty or damp locations, and do not
expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating
environment.
NCT-5MLC-E2 Eyeball Camera
Quick Start Guide
Camera
Quick
start
guide
Plastic
plug
×3
Drill
template
Allen key
Tapping screws × 3
■
Please re
ad these instructions carefully before operating the unit
and keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without
notice.
■
Visit nuvico.com for additional downloads, manuals, and resources.
*
1 It
is
recommended
to
install
the
security
cap
for
outdoor installation
.
*
2
If
the
PoE switch is
used
to
power
the
camera, DC12V
power supply
is
not
required
.
Secu
rity C
ap
Ethernet connector
Micro
SD card slot
Power
connector
Audio
input
Reset
1
5
2
6
3
7
8
4
Fixed screw
Mounting base
Fixed Screw
Mounting Base
Enclosure
Dome
Microphone
Before you start, please make sure that the wall or ceiling is strong
enough to withstand three times the weight of the camera. Please
install the camera in a dry environment.
①
Loosen the fixed screw to disassemble the camera.
②
Unscrew the cover of the dome and then insert a micro SD card.
After that, install back the cover and make sure the cover is installed
firmly.
Insert a micro SD card
Cover
③
Drill the screw holes and the cable hole on the ceiling according
to the drill template. Then route and connect the cables.
Earth wire connection
(
mm
)
Ø91.9
Ø63.8
Ø4.5
1
2
3
4
5
6
7
8
DC12V
