32
manually by using the safety valve on the right hand side. Check that the chamber manometer
drops to zero and then close the valve. The valve is opened by slightly turning it clockwise. A
“click” sound is heard when it gets in to the closed position.
Error 10: Low Pressure
The pressure in the chamber remains below the prescribed program pressure after the
sterilization phase has started.
Error 11: Low Temperature
The temperature in the chamber remains below the prescribed program temperature after the
sterilization phase has started.
Error 12: High Pressure
The sterilization pressure exceeds the maximum permitted pressure.
Error 13: High Temperature
The sterilization temperature exceeds the maximum permitted temperature.
Error 14: Air-in Time Exceeded the Limit
The pressure has not reached the predetermined value in the predetermined time during air in
phase.
Error 15: Steam Supply to Gasket Time Exceeded
Gasket pressure has not reached the predetermined value in the predetermined time when the
cycle starts.
Error 16: Insufficient Water in Vacuum Pump Reserve Tank
The water in vacuum pump reserve tank is insufficient.
Error 17: Insufficient Water in Steam Generator
The water in steam generator is insufficient.
Error 18: Drying Phase Vacuum Time Exceeded
Vacuum level has not been reached in the predetermined time during drying phase.
Error 19: Water Level Failure in Vacuum Pump Reserve Tank
Water level sensor in vacuum pump reserve tank has failed to read the water level during a cycle.
Error 20: Water Level Failure in Steam Generator
Water level sensor in steam generator has failed to read the water level during a cycle.
If an error occurs, please contact with an authorized Nüve agent to seek technical help.
Summary of Contents for NC 300
Page 12: ...12 5 6 GENERAL PRESENTATION Figure 3 1 2 3 4 5 6 7 8...
Page 18: ...18...
