12
Before operation starts, check that the safety thermostat value is higher than the
temperature set value.
6.2.
COMPLETION OF THE WORK
Observe that the program is over.
Stop the operation by pushing the “start/stop” button.
Take the samples out.
You may leave the incubator at the stand-by position or switch it off.
If the instrument is in START position in case of the open door, it will keep operating
and the heaters will be over-heated. Therefore, the heaters and other components
may be defected. Please be careful.
Be careful while handling the samples after the operation as they can be hot.
7.
PERIODIC MAINTENANCE AND CLEANING
7.1.
PERIODIC MAINTENANCE
The incubator does not require any periodical maintenance.
7.2.
CLEANING
Clean the incubator and at room temperature after disconnecting the power cable.
Clean the incubator with a wet cloth to remove dirt and dust.
Use liquid detergent to remove tough dirt.
Take precautions handling chemical cleaners. Please be aware of the undesirable effects of
the chemicals and be careful while applying them.
Check the external condition of the device regularly and ensure any rust spots that may
develop are removed.
8.
DISPOSAL MANAGEMENT CONCEPT
The currently valid local regulations governing disposal must be observed. It is in the
responsibility of the user to arrange proper disposal of the individual components.
All parts which may comprise potentially infectious materials have to be disinfected by suitable
validated procedures (autoclaving, chemical treatment) prior to disposal. Applicable local
regulations for disposal have to be carefully observed.
