Q & A
1.
The machine cannot be energized.
a)
The Lid Cover was not closed well.
Close the Lid Cover.
b)
The Fasten Screw is not locked well.
Screw the Fasten Screw firmly.
2.
No noodles are coming out.
a)
Too much water during mixing.
Take the paste out and tear into small pieces, put it into Mixing tank again with some
more dry flour, then press “Automatic”.
b)
Too little water during mixing.
Take out the Noodle Molding, and replace with a new molding (immersed in water first).
Then add some more water and press “Automatic”.
3)
No button reaction or motor does not work.
a)
No reaction after press “Extrude”.
In order to avoid dry paste blocked the Noodle Molding Hole; the program was set to
finish the mixing process first. If the paste is mixed well and you want the noodle come
out immediately, keep pressing “Extrude” for 3 seconds the noodle will start come out.
b)
No reaction of time button.
After press “Mix” or “Extrude” within 3 seconds, when the LED is still flashed you can
press the “+” or “-” to set the time.
4)
Noodle isn’t coming out correctly or motor sounds like it’s struggling.
a)
You can add egg, salt or some oil during mixing, this will make noodle better.
b)
If you have time you can tear the finished noodle into small pieces, and put into tank
again, the noodle come out in second time will be better.
5)
After it is finished there is still paste left in tank.
Our noodle maker has the highest noodle rate in market, but of course it will not become
noodle in 100%, there is still about 25g paste will be left. If there is paste left, you can take it
out and cook with the noodle.
a)
If the noodle come out time is too short and causes paste left in tank, just set the noodle
time to longer.
b)
If the paste is too wet and causes paste left in tank, you can take out the paste and tear
into small pieces and put back into tank. Then add some more dry flour and set the
mixing time at 10-30 seconds.
