READ & SAVE THESE INSTRUCTIONS!
INSTALLATION INSTRUCTIONS
®
5" Patio Speaker
MODEL: IS-419 SERIES
•
Recess-mounted using NuTone Model: IR-50 Rough-In
Frame.
•
When an enclosed rough-in is desired,
use NuTone Model: IR-55 Rough-In Frame.
•
Rough-In Frame(s) are sold separately.
ROUGH-IN FRAME MOUNTING
The speaker is mounted to the IR-50 or IR-55 Rough-In
Frame.
NEW CONSTRUCTION
NOTE: Refer to the instructions packaged with the
rough-in.
The rough-in frame is mounted to a wall stud during
rough-in construction. The wiring is ran from the master unit
to the speaker location. The speaker is then mounted to the
rough-in frame once the wall is in place.
EXISTING CONSTRUCTION
NOTE: Refer to the instructions packaged with the
rough-in.
The rough-in frame requires a cutout to the finished wall.
The frame may be mounted either directly to a wall stud or
between the wall studs. The wiring is installed through the
existing wall.
WIRING CONNECTIONS
1. Refer to Figure 1. Remove plastic clip that holds the
rubber gasket to the printed circuit board.
2. Refer to Figure 2. As illustrated, connect wires from the
master unit to the six (6) screw terminals. Red wire to the
terminal marked red, red/white wire to the terminal marked
red/white, etc.
3. Refer to Figure 3. Fold rubber gasket over installed wiring.
Hold gasket tab to printed circuit board by folding tab over
and sliding the removed plastic clip over tab and printed
circuit board.
PLEASE SEE OTHER SIDE
FIGURE 1
FIGURE 2
FIGURE 3
GASKET TAB
IS-419
PRINTED
CIRCUIT
BOARD
PLASTIC
CLIP
RED
RED/WHITE
BLACK
BLACK/WHITE
ORANGE/WHITE
PRINTED
CIRCUIT
BOARD
PLASTIC CLIP
GASKET TAB
IW-6 CABLE
RUBBER
GASKET
ORANGE
