JUMBO 7000 HFK SCISSOR
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
24
11.5.
BLEEDING and EQUALIZATION OF THE LIFT
[TR8]
•
Make sure there is no external leaking of hydraulic fluid.
•
Use the handle to raise the lift to the highest position.
•
Once the lift reaches the maximum height, continue allowing the motor to run for approximately 30 seconds,
adding fluid if necessary.
•
This allows the Hyperflow system to circulate all air back to the hydraulic reservoir!
12.
Final Installation Checkout Instructions
1.
Review
Operation Instructions on pages 9-10.
2.
Perform
all steps as outlined in the Operation Instructions on pages 9-10.
3.
Verify
all operations function properly and securely
.
4.
Demonstrate the operation of the lift to the owner/operator and review correct and safe lifting procedures using
the ANSI/ALI Lifting It Right booklet as a guide.
5.
Provide the complete lift documentation package to the owner for future reference.
6.
Complete
the Manufacturer’
s Checklist below and
Review
with the Owner.
7.
Review
the terms of the warranty registration card.
8.
Complete and Return
the card
along with a copy of the completed Manufacturer’s Checklist
to:
Nussbaum Automotive Solutions, LP
1932 Jordache Court
Gastonia, NC 28052
Fax: 1-704-864-2476
Email:
If the lift raises abruptly from its lowest
position, the platforms are unequal. Also if the
lift does not completely lower, bleeding might
be necessary
