Operating Manual and Inspection Book
POWER LIFT HL 2.30 NT / HL 2.35 NT / HL 2.40 NT
20100016 OPI
- 31 -
Version 1.1
Figure 3: To release the fixture plate, the rear lever must be
pushed.
• The lifting arm block must be ratcheted in after the fixture point has been reached.
• After each set down of the vehicle, check the lifting arm positions below the fixture points
again and adjust as required.
• Check that there are no people or objects in the hazardous area of the lift.
5.2 Lifting the vehicle
• Lift the vehicle until the wheels are off the ground. Push the operating lever forwards =>
"Lift" (see figure 4).
• If the wheels are not blocked, interrupt the lifting process and check for proper seating of
the carrier plate. Similarly check whether the lifting arm blocks are ratcheted in. Otherwise,
lower the lift and reposition the vehicle.
• After each set down of the vehicle, check the lifting arm positions below the fixture points
again and adjust as required.
• Check that there are no people or objects in the hazardous area of the lift.
• Afterwards, lift the vehicle to the desired working height.
Ensure secure vehicle placement on the carrier plate, otherwise there is a danger of the
vehicle dropping.
See to it that the lifting arm blocks are ratcheted in after the vehicle has been
accepted.
Summary of Contents for HL 2.30 NT
Page 2: ......
Page 94: ...Notes ...
