Nussbaum ATT Rugboard, Operating Instructions Manual, Page: 36 / 42

36 06.12.07 AD U9001 N
The VNC Server configuration window will open up.
Do all settings as shown in the picture. Enter 'gooroo' as the
password. Finish this job by clicking 'apply'.
You will now see the blue-yellow symbol for the server on the task
bar.
4.4 Rugboard-Einstellungen
Press the power button shortly, that you find on the upper right
side of the Rugboard. Wait until you see first the boot screen,
then the start screen. On this start screen, there are two servers
preconfigured. If you are using the wireless mode 'Peer-to-Peer',
and the server is running on a PC with one of the IP addresses
192.168.100.1 or 192.168.100.2, there are no further configu-
rations required. Otherwise, press the button 'Settings' on the
start screen, and follow the steps described below.
If the button 'Settings' should bot be there, follow the
procedure given in 4.4.6.
In brief, you will have to change to 'Infrastructure/Accesspoints'
if needed, or maybe change the IP address for the server you
wish to use. If you need to enter letters or numbers, you do this
with the Softkeyboard, which you can activate by pressing the
button (3) on the right top of the Rugboard, above the screen.
After pressing 'Settings':
From here, you have the following options:
- Settings - general settings like date, time, sleep mode etc.
- Network - Network and server properties
- Calibration - Calibration of the touchpad
- Factory Settings - Sets everything back to factory defaults
- Language - Language selection