DSP LASER AP with MCS
10.4.2.6. Connection to the Encoders monitoring Y1 and Y2
The connection to the encoders which monitor the cylinders Y1 and Y2 is achieved
connecting directly, in parallel, the channels A and B of each cylinder, using a shielded cable,
3 poles + shield. The shield must be connected to 0V ENC of only one device, to CNC or to
MCS.
The reference 0V ENC of each encoder is connected to one of the three poles of each cable,
on CNC side, and together with terminal 0V ENC towards MSC.
Take the encoder signal from the CNC terminals to realize the shortest connection possible
with MCS.
Avoid absolutely to lay the two shielded cables inside the electric panel near the power
cables.
Figure 38
DLAM01EN
49
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
