43
6.13 Torch
The built in torch will help you find your way
in the dark without switching on the
overhead light and possibly disturbing your
baby.
1. You switch the torch on by holding down
the
Torch on/off
for
4 seconds.
The torch
lights up.
2. You switch the torch off by again holding
down the
Torch on/off
for
4 seconds.
The torch
goes out.
7. Cleaning and care
7.1 Cleaning
Warning!
To avoid the risk of
electric shocks, injuries and
damage:
– Always disconnect the mains
adapter from the power socket
before cleaning the device.
– Never immerse the individual
parts in water.
Caution!
Under no circumstances use
abrasive, corrosive or scratching cleaning
agents, as these could damage the device.
1. If necessary, wipe the individual parts
with a damp cloth.
2. Only use the baby monitor again when all
the parts have fully dried out.
7.2 Changing the battery
The installed 3.7V 1200 mAh lithium polymer
battery (LiPo) may be replaced only by a
genuine replacement battery as used by us.
If necessary please contact our Product
Service (see "Product service babyphone in
Europe“ on page 143).
1. Remove the battery cover
on the back
of the parent unit
, by sliding it
downwards.
2. Remove the defective battery.
3. Put the new battery in its compartment
as indicated on the unit. Make sure you
insert it with the correct polarity (+ and -).
4. Slide the battery cover
back onto the
.
5. Initially, charge the parent unit
continuously
for 10 hours
to activate the
full battery capacity (see "4.1 Connecting
the parent unit" on page 33).
HI
flashing
The temperature has risen above
the upper threshold of 35 °C.
The room temperature has
reached an extremely critical
level and urgent action is
required to reduce the
temperature in the nursery.
Display
Significance / Action
