22
mynugeni.com
Note: Ensure beater bar is
installed properly before
use to avoid damage to unit
and compromised cleaning
efficiency.
Normal Mode:
20
min.
Turbo Mode:
16
min.
Typical Run Times:
U P R I G H T
Power Up
1. Press power button to turn unit on.
> normal mode: solid green light
Normal Power
2. Press power button again to activate
Turbo Mode for enhanced suction power.
> turbo mode: solid blue light
3. Press power button again to turn unit off.
Turbo Power
Note: Motorized beater bar runs
in both normal and turbo mode.
1. Slide access door release
lever sideways.
2. Lift access door open.
3. Flip up locking clip on end
of beater bar.
4. Grasp clip and pull firmly
upward in diagonal
direction to remove beater
bar
Removal
Turn power off. Do not try to access
beater bar while vacuum is running.
3
1
2
4
5. Insert fixed end of beater
bar at downward angle,
ensuring proper alignment
of drive sprocket tabs.
6. Press other side of beater
bar down until fully seated
into opening
7. Flip locking clip down and
press to “snap” secure
8. Close access door and
press to “click” secure
5
6
7
Motorized Beater Bar:
Replacement
Cleaning
Regularly inspect beater bar for blockages: including hair, fibers, and large debris
Maintaining a clean beater bar greatly improves upright vacuum performance.
Use scissors or sharp knife to cut through tangled hair and fibers once beater bar is removed.
WA R N I N G
!
Note: Upright vacuum and
beater bar are not designed
for use on rugs/carpets
with long fibers or extra
plush pile.
Note: Beater bar will turn
off automatically when
jammed. If this happens,
turn vac off, clear jam, then
restart vac.
Note: Beater bar can be removed for cleaning.
When necessary, follow these instructions:
