Chapter 4: Additional Local Configuration
48
TouchPoint Console Installation and Setup Guide
CAUTION:
If more than one fax machine is controlled by TPC, ensure that you choose the correct setting per fax
machine.
3
Press OK to save the change to the server.
The fax machine is now ready for use.
Outbound Calling Settings
NOTE:
These settings are only applicable for legacy fax board. New fax boards do not require the following
configuration steps.
Before starting, ensure that the fax device is connected to the phone line, and that the fax device is powered on.
1
On the Administrative Options screen, press Fax Devices.
2
In the Fax Devices screen, either press either V.34, Non V.34, or press Auto Detect if you are not certain.
3
As per the Auto Detect help area, ensure the fax device is correctly connected to TPC, then place some paper in the
fax device. Dial 123, press the # symbol, then press Send/Start. TPC will automatically detect the correct setting for
the attached fax machine after you dial the fax machine.
CAUTION:
If more than one fax machine is controlled by TPC, ensure that you choose the correct setting per fax
machine.
4
Press OK to save the change to the server.
The fax machine is now ready for use.