1.0 Introduction
The dMEV+ 2 speed axial extract fan has been designed for
continuous ventilation for kitchens or wet rooms and should
be installed using 100mm dia. ducting. The unit can be installed in
multiple application types, through wall, in duct and in room.
Speed settings are fixed at either Low Speed and Low Boost or
High Speed and High Boost (See Wiring Section for Details).
As a default, the fan is set to achieve low speed (6 l/s - wetrooms) to
adjust to high speed (8 l/s - kitchen) refer to section 10.
2.0 Handling
Always handle the the fan carefully to avoid damage and distortion.
4.0 Induct Installation
3.0 Installation
The installation must be carried out by competent personnel in
accordance with the appropriate authority and conforming to all
statutory and governing regulations i.e. IEE, CIBSE, CCHSE, HVCA etc.
The unit is suitable for indoor use only, and is suitable for induct or
wall and ceiling installation. Mount on a secure, vibration free surface
away from any direct source of heat and areas where it would be
subjected to water spray.
The maximum permissible ambient temperature is 50oC.
Please note that the fan clip supplied with the unit must always be
used for installing the fan to a mounting surface.
dMEV+ box contents
Fan unit, electrical cover, wiring grommet and a cable clamp.
2 part inlet grille, 3 anti-vibration pads, 2 part mounting bracket
and spacer.
NOTE: Unit identifier label maybe removed from front cover
once installation / commissioning has been completed.
10. 05. 17. Leaflet Number 671650
dMEV
+
Decentralised Mechanical Extract
Ventilation 2 Speed Axial Extract Fan
Installation Guide
The EMC Directive
2014/30/EU
The Low Voltage
Directive
2014/35/EU
Fig. 1
Peel off the 3 anti-vibration pads, and attach them to the insides of
the 2 part bracket.
Then attach this half of the bracket to a secure surface.
Fig. 2
Fan components.
Fig. 4
Fig. 3
Fig. 2.
Fig. 1
Wiring
grommet
Access to internal
wiring (see fig. 4).
Electrical
cover.
Cable clamp.
Impeller.
Position for front
edge of bracket
Cable clamp
Customer wiring
SL
L
N
Low High
Unit is fixed speed.
Select between either
Low or High speed with
the jumper position.
i.e. Bathroom installation
Low speed (Pre-set
factory position).
Fig. 3
Complete the internal fan wiring, and secure wiring using the cable
clamp, make a hole in the wiring grommet and insert into the cutout on
the fan wiring casing. Feed the wiring through the grommet and the outer
fan casing for later connection. Fit the electrical cover with 2 screws.
Fig. 4
Press the fan into the bottom half of the bracket and secure the
top half of the bracket to the lower half ensuring that the bracket is
positioned correctly on the fan.
Speed Setting
Nuaire: A Trading Division of Polypipe Limited
Western Industrial Estate
Caerphilly United Kingdom CF83 1NA
T: 029 2088 5911 F: 029 2088 7033 E: [email protected] W: www.nuaire.co.uk
1
