29
A
B
C
D
E
H
E
D
G
F
F
AFTER USING THE MACHINE
The following operations must be carried out after using the machine at the end of work.
•
Remove and clean the brushes or abrasive discs, following the procedure described in the “Maintenance -
Cleaning the disc brushes” chapter.
•
Empty the tanks, following the procedure described in the specifi c section.
•
Remove and clean the squeegee, following the procedure described in the “Maintenance - Cleaning the squee-
gee” chapter.
•
Recharge the batteries if necessary, following the procedure described in the “Maintenance - Charging the
batteries” chapter.
•
Store the machine in a dry and clean place with the brushes or abrasive discs and squeegee raised.
LONG MACHINE DOWNTIME
In the event of a machine downtime longer than 30 days, the following steps should be carried out:
•
Follow the instructions reported in the “After using the machine” section.
•
Clean the detergent feeding system (upon request), as described in the “Emptying the 5-Litre detergent tank”
(DETERSAVER) section.
•
Disconnect the battery connector as described below.
•
Lift the lever (A) to unlock the battery compartment door (B) and use the handle to open it (C).
•
Remove the battery holder case (D) by pulling the handle (E) until reaching the locking tabs (F) located on the
door (B).
•
Disconnect the battery (H) connector (G).
•
Put the battery holder case (D) back in its seat, close the door (B) again using the handle (C) until the lever (A)
is automatically locked.
•
Store the machine in a dry and clean place with the brush(es) or pad holder and squeegee removed or raised.
H
Summary of Contents for CHAMP 2417 RB
Page 2: ...2 NSS...
