NSK Ti-Max S-Max Series, Operation Manual, Page: 8 / 76

6
CAUTION
ō
Always keep the bur/drill shank clean. Dirt or debris in the chuck could cause poor bur/drill concentricity or low chuck
retention force.
ō
Always insert the bur/drill all the way into the chuck. If insertion is insufficient, premature failure of the bearings or
accidental release of the bur may occur.
ō
Do not exceed Max. Bur/Drill Length shown in "10. Specifications".
ō Always follow the instructions provided by the bur/drill manufacturer.
ō
Do not exceed the bur/drill speed recommended by the bur/drill manufacturer.
ō Should the handpiece function abnormally during use, stop using the handpiece immediately and contact your Authorized
NSK Dealer.
ō Do not use the following fluids to wipe, immerse or clean the product; strong/super acid water, strong acid/alkaline
chemicals, chlorine-containing solutions, solvents such as benzine or thinner.
ō The handpiece is delivered in a non-sterile condition and must be autoclaved prior to use.
ō
Perform regular function and maintenance checks. (Refer to "9. Periodical Maintenance Checks")
ō If the handpiece has not been used for a long period, rotate the handpiece and check for noise, vibration and overheating
before use.