NSK Ti-Max NLX nano, Operation Manual

Page: 10 / 38

English
9
9. Error Code
Error
Code
Trouble Cause Check/Remedy
E0 Overcurrent error.
(In circuit) Detected overcurrent in the circuit. Contact your dealer.
E Overcurrent error.
(In software) Detected overcurrent in the software. Contact your dealer.
E2 Retry Error Motor stopped by the overload, and not
able to restart. Contact your dealer.
E3 ITRIP Error Faulty Motor or Internal circuit. Contact your dealer.
E5 Overvoltage Input Error Overvoltage is given to the Control Box. Contact your dealer.
E6 LED voltage Error Overvoltage is given (more than 3.7V)
from the Internal circuit. Contact your dealer.
E8 Overheat Error High temperature safe system is
functioning, due to long-time use at a high
load. Cool it down for a while, and try again.
E9 Motor Start Error - Motor didn't reach the preset speed in a
prescribed period of time.
- Break down of a motor cord wire, or
internal circuit malfunction.
Contact your dealer.
EA LED voltage Error Voltage for the LED didin't reach the
preset speed in a prescribed period of
time. Contact your dealer.
Eb Air Offset Error Lower than preset " Lower limit of the air
pressure" Displayed by Foot Air Calibration function.
Not a malfunction.
Ec Air Full Scale Error - Higher than preset "Upper limit of the air
pressure".
- Air pressure higher than 0.4MPa (4.0kgf/
cm
2
) is given.
Displayed by Foot Air Calibration function.
Not a malfunction.
EE EEPROM Error Malfunction of the memory for the setting
values. Contact your dealer.
If the motor stops due to an abnormality such as a malfunction, overload, break or incorrect usage, it automatically checks
the state of the Control Box and detects the cause of the abnormality and displays an error code on the Indicator. If an error
code is displayed, turn on the power again and check whether the same error code is displayed. If the same error code is
displayed, take action by referring to the instructions provided in the "Check/Remedy" column in the following table.
CAUTION
It might happen if the O-Ring becomes depleted.
· Air/Water leak
· Air/Water does not came off
· Vibration
· Difficult to connect/disconnect the handpiece