NSK Bruel & Kjaer Vibro VCM-3, Instructions Manual, Page: 3 / 22

© Brüel & Kjær Vibro
● C107759.002 / V03
Page 3 of 22
Technical alterations reserved!
Brüel & Kjær Vibro
│
Instruction VCM-3 On-Site Commissioning Table of Contents
EN
UNRESTRICTED DOCUMENT
Table of Contents
1 Introduction .............................................................................................................. 4
1.1 Scope ..................................................................................................................................................... 4
1.2 Firmware version .................................................................................................................................. 5
1.3 Document Conventions ....................................................................................................................... 5
2 On-site Commissioning of VCM-3 .......................................................................... 6
2.1 Prerequisites ......................................................................................................................................... 6
3 Initial Power Up test
– Visual check ....................................................................... 7
3.1 Investigation of deviations in LED colors after initial power up ...................................................... 9
3.1.1 Sensor problems on connected sensors (signal inputs) ......................................................................................... 9
3.1.2 CCS (constant current supply) sensors .................................................................................................................. 9
3.1.3 Non-CCS sensors ................................................................................................................................................ 10
3.1.4 VCM-3 hardware (device) problems ..................................................................................................................... 10
4 VCM-3 Homepage Commissioning Procedure .................................................... 12
4.1 Log into the VCM-3 Homepage .......................................................................................................... 12
4.2 Check the VCM-3 firmware version and update firmware .............................................................. 13
4.3 Check the Operational Status ............................................................................................................ 14
4.4 Check bias voltages of sensors ........................................................................................................ 15
4.5 Make tap test of the accelerometers ................................................................................................. 16
4.6 Configuration ...................................................................................................................................... 17
4.7 Document the completed commissioning process ........................................................................ 18
4.8 Completing on-site commissioning
– visible check ....................................................................... 19
5 Appendix 1: Update VCM-3 firmware ................................................................... 20
6 Appendix 2: Power Up/Down and Reboot ........................................................... 21