Page 4
REQUIRED POLISHERS
When working in a home, a variable speed, right angle electric polisher (typically 7” to 9”) will be used
for the entire process. The slow speed selections on this type of polisher allows for ultimate control
with minimum mess. Many polishers will work but a good quality, well balanced polisher results in less
fatigue and a more relaxed, enjoyable experience. Below we have listed the minimum electric polisher
requirements as well as some additional features that are useful. Check out our videos to see which
polishers we use and prefer.
1.
Electric polisher – required features:
a.
5/8-11 arbor threads (USA) or 14mm arbor threads (Europe)
b.
Variable speed down to approximately 600 RPM
2.
Electric polisher - additional desirable features:
a.
Variable speed trigger control down to 0 RPM
b.
Trigger lock on feature
c.
“Soft” startup feature
When working in a wet fabrication shop, the same electric polisher can be used for the entire process if
desired but it is generally easier and quicker to switch to a center water feed, pneumatic polisher when
using the Redeemer Resin pads. The center water feed pneumatic polisher provides more water and a
higher speed and will achieve a polish quicker when overspray and splatter is not a concern.
3.
Pneumatic polisher – required features:
a.
5/8-11 arbor threads (USA) or 14mm arbor threads (Europe)
b.
Approximate speed 4000 RPM
c.
Center water feed
