NSD VE-2CC, Specifications & Instruction Manual

Page: 18 / 32

13
5. INSTALLATION AND PRECAUTIONS
5-1. Converter Installation Conditions and Precautions
The installation conditions and precautions for each of the system components are described in this section.
- Installation Site
(1) Avoid sites where the unit is exposed to direct sunlight.
(2) The ambient temperature should never exceed a 0 to 55°C range.
(3) The ambient humidity should never exceed a 20 to 90% RH range.
(4) Do not install the unit in areas where condensation is likely to
occur (high humidity with extreme temperature changes).
(5) Avoid sites where dust is excessive.
(6) Do not install in areas with an excessive amount of salt and/or metal chips.
(7) Do not install in areas where flammable and/or corrosive gases are present.
(8) Avoid areas where splashing water, oil or chemicals are likely to occur.
(9) Avoid areas where vibration and shocks are excessive.
- Installation cautions
(1) Secure tightly with two pieces of M4 screws.
(2) Install as far from high voltage lines and power lines as possible in order to minimize noise influences.
(3) Allow 85mm or more space at the converter's front side for plugging in and unplugging the connector.
5-2. ABSOCODER Sensor Installation Conditions and Precautions
(1) Do not subject the sensor to excessive
shocks and unbalanced loads.
(2) If connected to a shaft, a coupling format
should be used.
For the installation conditions and precautions for ABSOCODER sensor, refer to “ABSOCODER HANDLING
PRECAUTION” (NSP-Z2022). This manual is available upon request.