TA600032-EN0/0
- 71 -
Pull up the input pin of "Virtual local LSI additional count" with a resistance of about 10 kΩ.
"MRER", "MSEL", and "TOUT" pins do not have built-in pull-up resistors.
Connect a resistor of about 1kΩ to the switch.
When driving an LED, use a CMOS buffer whose low-level input current (I
IL
) is 10 µA or lower.
6.3.3
Virtual local LSI additional count setting error
"Device number" of "Virtual local LSI" is a consecutive number from the "Device number" of "G9006".
When a "Device number" of "Virtual local LSI" exceeds "63", a "Virtual local LSI additional count setting error" (MSTS.EAER)
occurs.
When the "Virtual local LSI additional count setting error" occurs, "G9006" sets "MSTS.EAER = 1".
The "Local CPU" clears the "Virtual local LSI additional count setting error" by properly resetting the "Device number" and
"Virtual local LSI additional count".
When the "Virtual local LSI additional count setting error" is cleared, "G9006" sets "MSTS.EAER = 0".
The "Virtual local LSI additional count setting error" is not an "Interrupt factor".
Therefore, "Interrupt request" signal (INT pin) is not output.
Be sure to set "MSTS.EAER = 0" when writing to the "RADD" (00h) register and when performing a reset with "DMOD = H
level".
3.3V
GND
MRER/RSV0
MSER/RSV1
TOUT/RSV2
CMOS Buffer
LED
×
3
1kΩ
×
3
10kΩ
×
3
