ASSEMBLY AND ADJUSTMENT INSTRUCTIONS
Before beginning the assembly, please check that all parts are enclosed.
PART LIST
ASSEMBLY
1. Press wheels onto chair base.
NOTE: H type wheels – onto soft base
W type wheels – onto hard base
2. Pull gas lift cover over the gas lift.
3. Insert cover collar into gas lift (from botton).
4. Insert the gas lift into base.
5. Firmly locate the tapered end of the gas lift into locating hole in the seat base.
6. Connect permanent contact device to the seat and tighten handwheel
B
. Slide the cover
over the guide.
7. Insert the back slider in the guide and tighten handwheel
A
.
ADJUSTMENT
The seat hight adjustment - lever
C
.
Gas lift allows the adjustment of the seat hight.
The back height adjustment - handwheel
A
.
By releasing handwheel
A
the back can be moved up and down.
Place the back at desired position and retighten handwheel
A
.
The back depth adjustment - handwheel
B.
By releasing handwheel
B
the back can be moved forward and back.
Place the back at desired depth and retighten handwheel
B
.
The back tilt adjustment - knob
D.
MAINTENANCE
Inspection
Inspect chair at least every six months
to make sure all knobs, bolts and screws are tight.
Vinyl upholstery
Wipe with damp cloth, moistened in a mild detergent
solution. For unusual stains use commercial vinyl cleaner, following
manufacturer`s instructions.
Fabric upholstery
Whisk or vacuum regularly. For unusual stains use
commercial nylon cleaner, following manufacturer`s instructions.
Other surfaces
Wipe with a soft cloth, moistened in
a mild detergent solution. Dry and buff lightly with a dry cloth.
Attention
Exchange and installattion of gas-lifts should only be carried out by
trained specialists.
1 base
5 castors
1 gas lift
1 gas lift cover
1 cover collar
1 seat
1 permanent contact
1 guide cover
1 back with slider
1 handwheel
A
(short)
1 handwheel
B
(long)
Back
Slider
Cover
Base
Castor
Collar
Gas lift
Gas lift cover
Handwheel
B
Handwheel
A
Permanent
contact
Guide
C
D
Seat
JUPITER TS02
RTS PST01-CPT
NJGB5
