Operation Manual
Hardness Tester NOVOTEST T-UD3
Page. 36
2.3.11 Information
In this menu item, user can see information about the manufacturer and representative offices
around the world (Figure 2.45).
Figure 2.45 - Section <INFORMATION>
Also in this menu item the user can find information about the device and the number of
measurements, use the navigation keys <
> and <
> to open the required table (Figure 2.46).
Figure 2.46 – Information about the device and the measurements number
2.3.12 Photo fixation of the measurements
Photo fixation of the measuring point is used in models with a photo camera.
The user can install photo fixation mode in the device settings. For this go to the <SETTINGS>
section from the main menu, using the keys <
>, <
> select <PHOTO> and using keys
<
>, <
> change <OFF> to <ON>. Also in <SETTINGS> turn on the photo flash light. For this,
using the keys <
>, <
> select <FLASH> and by keys <
>, <
> change <OFF> to
<ON>. Then press <
> key to exit from <SETTINGS> section. Now the user can start measuring.
After measuring, in order to save the measurement (a series of measurements) to archive with
photo fixation of the measurement location, do the following:
1.
Press <
> key (ENTER). A keypad for entering the measurement name (a series of
measurements) appears on the display (Figure 2.47).