Operation Manual
Hardness Tester NOVOTEST T-UD3
Page. 21
Figure 2.11 – Entering the name for the saving measurement
12.
Select the required symbol and press <
>. After entering the name or saving result press
key <
> to save.
13.
If <PHOTO> mode is set on (See 2.3.12 for the details about the <PHOTO> mode), than the
device display will offer to <TAKE PICTURE> or <SAVE WITHOUT PHOTO> (Fig. 2.12).
Figure 2.12 – Mode <PHOTO>
14.
Press <
>
key
to save the measurements without photo, or <
> to make photo.
15.
Then press <
> key to save photo. Then, using navigation keys <
>, <
>,
<
> and <
> put the marker on the point, where the measurement was occurred, press
<
> key to save, or <
> to put another marker on the photo. Confirm saving of the
pointed marker by pressing <
> key – saving photo without possibility to add another
measument point (marker).
Note: The distance between the imprint center and the edge of the sample or another close-in
imprint should be at least 2.5 imprint diagonal length.
2.3.5 Measurements with the Leeb Probe (dynamic)
RESTRICTION: limited use for measuring objects with weight less than 5 kg or thickness less
than 10 mm without additional preparation! Typically, such products must be
ground to a massive polished plate.
1.
Prepare the tested object before taking measurements as in p. 2.3.1.