Operation Manual
Hardness Tester NOVOTEST T-UD3
Page. 14
2 INTENDED USE
2.1 Operational limitations
Operation of the device should be carried out under the influence of factors and taking into
account the parameters of the monitored objects in accordance with the specified technical
characteristics. The device must be used within its technical characteristics.
Only qualified personal, familiar with the operation manual is allowed to use this device.
After transporting the device at temperature below zero to the place of operation and bring it into
the room with a positive temperature - it is necessary to keep the device in its package for at least 6
hours in order to avoid failure due to condensation of moisture.
2.2 Preparing the device for use
2.2.1 Visual inspection
Carry out visual external inspection of the device; make sure that there are no mechanical
damages to the electronic unit, the probe, the connector and the connecting cable.
2.2.2 Installing the batteries
Install the batteries into the battery compartment by unscrewing the two fixing screws and
removing the battery cover. Batteries are to be installed according to the polarity indicated on the
device (Figure 2.1). Close the battery compartment cover and screw in the screws.
Figure 2.1 - Installing the batteries