4 MAINTENANCE
The device by type of performance and taking into account operating conditions refers to
products that are repaired at special enterprises or at the manufacturer.
To set the device for warranty service in the service center (SC), it is necessary to present
correctly completed SERVICE AND MAINTENANCE RECORDS for the device. SC makes a
mark in the SERVICE AND MAINTENANCE RECORDS about setting the device for
warranty service and sends a photocopy to the manufacturer.
Sending the device for warranty (post-warranty) repair or verification should be done
with the O.M. or SERVICE AND MAINTENANCE RECORDS of the device. In the
accompanying documents it is necessary to indicate the mailing details, telephone and fax of
the sender, as well as the way and the address of the return delivery.
Warranty repair is carried out in the presence of a completed SERVICE AND
MAINTENANCE RECORDS.
5 STORAGE
Storage conditions for the device in group 1 in accordance with the requirements of
GOST 15150 at an ambient temperature of +5 ° C to +40 ° C and a relative humidity of up to
80% at a temperature of 25 ° C.
Recommended temperature for long-term storage is 10 ° C - 30 ° C.
For short-term storage and between use, the device should be stored in the intended
packaging.
The storage area should be free from vapors of aggressive substances (acids, alkalis)
and direct sunlight. The device must not be subjected to sharp shocks, drops or strong
vibrations.
6 TRANSPORTATION
Packaged devices can be transported by any means of transport, subject to the
following conditions:
− transportation is carried out in the original container;
− there is no direct exposure to moisture;
− the temperature does not go beyond the range from -50 ° С to +50 ° С;
− humidity does not exceed 95% at temperatures up to 35 ° С;
− vibration in the range from 10 to 500 Hz with amplitude up to 0.35 mm and
acceleration up to 49 m / s2;
− impacts with a peak acceleration value of up to 98 m / s
2
;
− the devices placed in the transport are secured to prevent falls and impacts.
−
To prevent moisture condensation inside the device when it is carried from frost to a
warm room, it is necessary to keep the device for 6 hours at room temperature before use.
7 RECYCLING
The product does not contain hazardous or toxic substances that can harm human health
or the environment and does not pose a danger to life, human health and the environment at
the end of its service life. In this regard, the disposal of the product can be carried out in
accordance with the rules for the disposal of general industrial waste.
Summary of Contents for NVS P1
Page 1: ...NVS P3...