Novexx ALX 924, User Manual

Page: 10 / 91

User Manual
ALX 92x
09/2016 | 00 10 Please note
FOR YOUR SAFETY
Intended use
Print & Apply systems of the ALX 92x series are designed for printing, dispensing and applying self-
adhesive labels using the direct thermal or thermal transfer procedure. The individual versions
(ALX 924, ALX 925, ALX 926) differ in the maximum print width.
Various combinations of thermal transfer ribbons and label materials are used and must be availa-
ble in the form of rolls.
The label material that is used must be punched, i.e. the self-adhesive labels adhere individually,
separately by punchings, on a carrier material. The labels must only adhere strongly enough so that
they will come loose when the material is deflected over a sharp edge.
Any other type of or more extensive application will be considered non-intended use.
NOVEXX Solutions shall assume no liability for damage resulting from non-intended use of the ma-
chine.
Information and qualification
Ensuring the necessary qualification
 Only fully trained and authorised personnel are permitted to operate, adjust and maintain the
machine.
 Service work must only be performed by qualified and appropriately trained technical specialists
(service technicians) or the customer service department.
 Areas of responsibilities for operating and servicing the machine must be clearly defined and
consistently observed.
 Personnel must also be regularly instructed in on-the-job safety and environmental protection.
Qualification for operation
The instruction provided for the operating personnel must ensure:
• that the operating personnel can use the machine independently and without danger.
• that the operating personnel can rectify minor operating faults (for example a paper jam) inde-
pendently.
 At least 2 persons should be instructed in operation.
 Have a sufficient quantity of label materials available for tests and instruction.
Qualification for system integrators and service technicians
Knowledge required to install the Print & Apply system and perform service work must be
demonstrated through appropriate qualification. Only service personnel with technical train-
ing are able to assess the tasks to be performed and recognise potential dangers.
• Knowledge acquired through technical training in mechanics and electronics (for example in
Germany the training to become a mechatronics engineer).
• Participation in a technical training course for the corresponding label dispenser offered by the
manufacturer.
• The service personnel must be acquainted with the functionality of the label dispenser.
• The system integrator must be acquainted with the functionality of the of the system into which
the label dispenser is being integrated.