Novexx ALX 924, User Manual

Page: 82 / 91

User Manual
ALX 92x
09/2016 | 00 82 Cleaning & Maintenance
SENSOR
Clean the sensors regularly to remove any material res-
idue and dust. The cleaning intervals depend on the
materials in use.
Cleaning the punch sensor
To access the punch sensor, first remove the guiding
section:
1. Switch off the machine.
2. Remove the mains power connecting line.
3. Remove material and ribbon.
4. Remove the bolts [72A] (using 3 mm Allen key).
5. Remove guide section [72A] from side.
6. Write down the position of the sensor thumb wheel
[73B].
7. Turn the thumb wheel to move the sensor fork all
the way to the outside .
8. Using compressed air, blow out the gap [73A] in the
sensor arm (canned air is available as an accesso-
ry).

If the sensor is heavily contaminated, use
cleaning solvent and a lint-free cloth to clean the
sensor.
9. Reinstall the guiding section and fasten it with the
bolts.

Push the guiding section with the groove [74A]
over the rear guide tab on the sensor fork [74B].
10. Move the sensor back to its original position.
[72] Removing the guiding section (B).
[73] Sensor fork (A).
[74] Guiding tab (B) at the sensor fork.
A
B
A
B
A
B