User Manual
XLP 604
CLEANING THE RUBBER ROLLERS
CAUTION!
Risk of damaging the roller.
► Never use knives or sharp-edged objects to clean the rollers!
Fig. 59: Position of the rubber rollers:
A
Print roller,
B
Feed roller,
C
Draw roller
It is recommended to remove the rollers completely for cleaning. This can be done easily and without
tools using the bayonet couplings.
An alternative is to turn the rollers by hand while they are installed, cleaning them step by step.
Procedure
1.
Switch off the machine.
2.
Open the front hood (A, figure below).
3.
Open the print head pressure lever (B, figure above).
4.
Remove one roller (see chapter “Maintenance” > “Rubber roller replacement”).
Only remove one roller at a time. As the rollers are connected by toothed belts, the bayonet
coupling of the removed roller can be prevented from turning by holding an installed roller. This
makes installation easier.
Edition 2 - 12/2021
109
Cleaning
Cleaning the rubber rollers
